Pull Pin Is Frozen On A Fulton F2 Trailer Jack
Updated 03/30/2022 | Published 03/28/2022
Question:
I just installed the F2 Jack and both the pull pin are frozen. I cant even move rotate the handle. Obviously I did something incorrect but before I unbolt again and reinstall, checking if maybe I over torqued a bolt or something that would cause this. I did loosen the height adjustments bolts and retighten them, could that be the problem?
asked by: Casey C
Expert Reply:
I spoke with Fulton, and they believe the issue with your Fulton F2 Swing-Up Trailer Jack is that there is dirt, grime or corrosion in the pull pin mechanism, and that is affecting its operation.
I recommend using some penetrating lubricant, or some WD-40 to spray the area to free it.
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Rebuilding Brakes on a EZ Loader Dual Axle Boat Trailer
- Q&A: Replacement Pull Pin Kit and Housing For Fulton F2 Trailer Jack
- Q&A: Best Option to Easily Move Travel Trailer in Garage
- Q&A: Weld-On Plate That Is Compatible With Fulton XLT Trailer Jacks
- Q&A: Fulton 1500-lb Bolt-Thru Pull-Pin Swivel Jack
- Q&A: Do the Fulton XLT Jacks Require Grease Upon Install
- Q&A: Bleeding Trailer Brakes After Installing Kodiak 225 Disc Brake Calipers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers