Installation Assistance With Mounting Hole Dimensions Optronics GLOLight LED Stop/Turn/Tail Light

Updated 08/29/2013 | Published 08/27/2013

Products Featured in This Question

GloLight Halo LED Trailer Light - Brake, Turn, Tail - Submersible - Round - Red

(443)

$28.43

Rubber Grommet for 4" Round Trailer Lights - PVC

(236)

$4.33

Three-Wire Straight Pigtail for Optronics Weatherproof Stop/Turn/Tail

(57)

$7.45

Trailer Light Mounting Bracket for 4" Trailer Lights, Steel - Black Powder Coat

(52)

$4.78

Question:

I see that the light is 4, what is the cut out hole size? I am looking to install these custom on my Jeep Wrangler. Also when the power is off is the unit reflective? does this come as pair or single unit?

asked by: TS

Helpful Expert Reply:

To install the Optronics GLOLight LED # STL101RMB you will also need grommet # A45GB.

There are two mounting options for this LED light. The first one is using Optronics grommet # A45GB and mounting directly into your 1998 Jeep Wrangler. The other option is using the Optronics Mounting Bracket # BK45BB.

If you decide to use the mounting bracket, you will still need the grommet as well.

If you are mounting using the grommet only the grommet opening is 4-1/2 inches. When cutting this out, start smaller and work your way out. The grommet is rubber so has some flexibility. After you have the hole drilled and grommet placed, simply push the Optronics # STL101RMB into the grommet. The more snug the fit, the better.

If you decide to use the mounting bracket, you will still need to drill the hole, starting off small, then attaching the bracket and then the grommet followed by the light.

For your power source the Optronics Three-Wire Pigtail # AL45PWTB is designed to work with this LED.

This light is not reflective when it does not have power.

Each light, grommet, pigtail and mounting bracket is sold individually.

I have attached a picture of the light inside the mounting grommet for reference.