How to Find Replacement Wheel Bearings for 2005 Haulmark Edge Race Car Trailer
Updated 03/09/2022 | Published 03/07/2022 >
Products Featured in This Question
Question:
i have a 2005 28 foot haulmark Edge race car trailer. how do i find wheel bearings for that? do you stock them?
asked by: Jeremy F
Expert Reply:
There are several possible ways to find the correct bearings for your 2005 Haulmark Edge trailer. The first is to check out your axle. If you have an axle tag with a serial number you could contact the manufacturer and more than likely they would be able to tell you the correct replacement bearings.
If you don't have an axle tag or it is worn off, you will need to pull off your hubs and take a look at the bearings. The part numbers are typically stamped in the side. It is also possible that they have worn off over time. If that is the case you will need to take some measurements.
I recommend using a digital caliper like the # PTW80157. The measurement you are looking for to identify the bearings is the inner diameter. You can either measure the bearings themselves or measure the spindle where the bearings ride.
I have attached a diagram showing where part numbers are typically found as well as where to measure. I also included a link to all of our bearings which can be filtered down by part number or inner diameter.
Product Page this Question was Asked From
Bearing Kit, LM67048/25580 Bearings, GS-2125DL Seal
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing LM67048 and 25580
- Race 25520 and LM67010
- 5200 lbs Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will the 6,000 lbs Dexter Nev-R-Adjust Electric Trailer Brakes Work on a 5,200 lbs Axle?
- Q&A: Bearing Replacements for Dexter 5,000 lb Trailer Axle
- Q&A: Bearing Kit for Dexter Trailer Axle D52
- Article: Most Popular Wheel Bearings
- Q&A: Can Grease Be Cleaned Off Of A Brake Magnet And Brake Assembly?
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Q&A: Brake Assembly Recommendation for a Dexter 4,400 lb Axle with 10 inch Assemblies
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide



