B and W Tow and Stow for 2.5 inch Hitch with 9 inches of Drop  

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hi Scott, Really good question and yes, all of the necessary hardware that is needed for installation comes with the Rhino-Rack Vortex Crossbars for Retrax XR and Mountain Top EVO-M Tonneau Covers #RRVA180B-RRRLT600. I've added a photo for you…

Hey Jonathan, congrats on the new truck. The 7" drop should be enough, but it is hard to say for sure without knowing what trailer you will be pulling. The 7" drop will get your ball height at 17" or 18" (we measure from the upper…

Yes, the Air Lift LoadLifter 5000 Air Helper Springs #AL57341 will fit your 2024 Chevrolet Silverado 2500 double cab with the Duramax diesel engine and factory puck system. We installed the upgraded Springs #AL88341 on a similar 2022 which I have…

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…

Hey Tim, the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 will indeed fit your 2024 GMC 2500 AT4X with a factory suspension lift. You will likely need to use a spacer kit to compensate for the lift, depending on the amount of…

With this truck bed configuration (6-3/4) on your 2024 Silverado 2500, you'll need a slider hitch so that you can make turns properly without the trailer making contact with your truck. I recommend the B&W Patriot #BWRVK3270 due to it's…

Hey Scott, We do have exactly what you need for both the rack and kit that allows mounting into the Vortex crossbars. It doesn't come with the bike rack so you'll need to get it separately, but what you're looking for is the following: -…