Can Rotopax Mounting Kit for Yakima OverHaul HD Fit Thule Bars

Question

Question:

Will this adapter also mount to a Thule Top track, the standard mount for Leer shells? Want a simple cheap way to mount a rotopax gas can to my leer shell.

asked by: Kaya

0

Expert Reply:

Yes, since the T-slots of Thule racks and Yakima racks are the exact same you can use the Rotopax Mounting Kit for Yakima OverHaul HD and OutPost HD Truck Bed Ladder Racks # Y01167 in the Thule tracks.

expert reply by: Jameson C

0

Answer 1

I may have a solution for you, but there is not a product that exists for this purpose. However, you might be able to install a Rhino Rack Universal Pioneer Platform for Crossbars #RR42115BF, which would give you the perpendicular mounting channels…

view full answer...

Answer 2

The Replacement Mounting Hardware for Recovery Tracks for Yakima Ladder Racks part #Y83FR uses M8 hardware per Yakima.

view full answer...

Answer 3

It sounds like you are asking about the largest fuel can you can attach to the Rotopax Mounting Kit for Yakima OverHaul HD and OutPost HD Truck Bed Ladder Racks #Y01167. If that is the case, this mounting kit has a weight capacity of 40 lbs. Although…

view full answer...

Answer 4

The Yakima SideBar Rails cannot be cut as the assembly does in fact involve one bar sliding into the other like you mentioned and it would not be structurally sound, but there is a short bed version of these rails, which is the SideBar Rails for…

view full answer...

Answer 5

Thanks for reaching out, Alex! The Yakima OutPost HD Overland Truck Bed Rack #Y01152-58 will be too short to fit the MOLLE Panel #Y98DJ, but you can use the SideBar Rails, Short Bed #Y01153 or Long Bed #Y01154, if you'd like to add some cargo…

view full answer...

Answer 6

Hey Justin, it doesn't look like the MOLLE Panel for Yakima OverHaul Truck Bed Racks #Y98DJ is available in pairs.

view full answer...

Answer 7

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 8

The correct height setting is going to vary by trailer but you can get there taking some measurements. First make sure your trailer is on level ground and then measure from the ground up to the bottom of the king pin. Then on your truck take a…

view full answer...

Answer 9

The actual puck itself is a standardized size between each brand so the only measurement that matters is the spacing of the pucks, which differs between each vehicle manufacturer. I've attached a diagram below with the spacings used by…

view full answer...

Can Rotopax Mounting Kit for Yakima OverHaul HD Fit Thule Bars

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching