Troubleshooting Middle Jacks Not Grounding On Lippert Ground Control 2.0 Leveling System

Updated 01/24/2022 | Published 01/22/2022

Question:

LIPPERT 2.0 6 POINT The middle jacks do not ground in auto level mode. They will go up and down but do not touch the ground

asked by: Adam M

Expert Reply:

Since the middle jacks are not grounding on your Lippert Ground Control # LC675817 and you are not receiving any type of error code. I recommend starting by doing a zero calibration on the jacks. To do this here are the steps from the owners manual.

1. Manually run the jacks to level the unit. This is best achieved by placing a level in the center of the unit and leveling it both front to back and then side to side.
2. Once the unit is level, turn off the touch pad.
3. With the touch pad off, press and release the “front” button 10 times and then press and release the “rear” button 10 times.
4. The touch pad will flash and beep and the display will read “zero point calibration enter to set, power to exit”.
5. To set the current position as the zero point, press the “enter” button.
6. LCD display will read “zero point stability check”.
7. LCD display will read “zero point set successfully” once process is complete.
8. The system will set this point as its level state and the touch pad will turn off.

If this does not fix the issue let me know if anything has changed by doing this calibration and I will help to determine the next steps.