What Size Hardware Is Needed For The Replacement Rubber Socket DH38S
Updated 01/04/2022 | Published 01/03/2022
Question:
what size bolts?
asked by: ROBERT S
0
Expert Reply:
The mounting hardware needed to mount the Replacement Rubber Socket for DH38R and DH39R # DH38S is 7mm by 16 threads per inch, and would use a 5/16-16" fastener.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Replacement Rubber Socket for DH38R and DH39R
- Accessories and Parts
- RV Door Parts
- Trailer Door Parts
- Door Holder
- Socket
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Plunger Door Holder Socket for a Polar 68 Socket
- Q&A: Longest Available Door Replacement Plunger
- Q&A: Correct Atwood LPCO 36636 Wires to Connect to RV Propane Gas and Carbon Monoxide Detector
- Q&A: Replacing Mobile Home Trailer Hub With a Hub that is Compatible with Standard Rims and Tires
- Q&A: Rear Door/Ramp Latch Placement for Horse Trailer
- Q&A: Can 2-Step Lippert Steps Replace a Single Step on a 2017 Winnie 170S
- Q&A: Wiring Diagram for a 1997 Peterbilt Semi Tractor with 7-Pin Round Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How (and Where) to Connect an RV Propane Grill