Parts Needed to Install Redarc Tow-Pro Elite Brake Controller on 2022 Subaru Ascent

Published 12/09/2021

Products Featured in This Question

Redarc Tow-Pro Elite Brake Controller - Dash Knob - Off-Road Mode - Up to 3 Axles - Proportional

(1676)

$290.00

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(123)

$39.97

Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Dual Plug In

(83)

$25.05

Redarc Tow-Pro Wiring Adapter for Tekonsha Brake Controller Harness

(96)

$27.00

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3397)

$121.25

Question:

I want to install the Redarc Tow-Pro Elite brake control in my 2022 Subaru Ascent. What parts do I need to do that? Thank you!

asked by: Bill J

Expert Reply:

The method you'd use to install the Redarc # RED44FR Tow-Pro Elite brake controller will depend on how your 2022 Subaru Ascent is equipped.

If you have the factory tow package which includes the 7-way trailer connector on the rear bumper, the only other parts you'll need other than the brake controller itself is the # 3062-P and the # 331-TPH-017. The # 3062-P would plug into the factory connector located above and to the left of the dead pedal, just above the kick panel as shown in the provided photo. The # 331-TPH-017 adapter would join the # 3062-P to the brake controller.

If you do NOT have the factory tow package, you'll need to hardwire in the controller. You'll begin by installing a functioning 4 pole trailer connector using # 118790. Then install the controller using our brake controller install kit, part # ETBC7. The install kit includes everything needed to complete the installation, including the wire, circuit breakers, hardware and even the adapter to convert the 4 pole provided by the # 118790 to a 7-way.

I've linked to some demonstration and product videos that you might find helpful.