Trailer Hitch that Fits 1987 Ford F-150 with 6,000 lb Towing Capacity

Question

Question:

Hello, I have a 1987 F-150. I am looking for a bolt on hitch. Would a 6000 lb hitch. Dont want to have to drill unless it is absolutely necessary. Any help would be appreciated. Thanks

asked by: Mike K

0

Expert Reply:

Due to the frame design of your 1987 Ford F-150 all hitch fits would require frame drilling since there aren't holes present on the frame. We do have great 6k rated hitches that fit your truck like the # 41004 though. This fits whether you have the standard or step bumper.

expert reply by: Jameson C

0

Answer 1

I went out to measure both Draw-Tite Trailer Hitches, #41904 and #41004. They will not use the same mounting locations. On #41904, the center to center distance between the two closest bolt holes is 4-3/4 inches. Between the center bolt hole and the…

view full answer...

Answer 2

The Draw Tite Hitch part #75038 has been confirmed as a fit for your 1996 Ford F-250 and will allow you to keep your spare tire mounted underneath your truck. If you check out the picture I attached you will see it installed with a spare still…

view full answer...

Answer 3

For your 1995 Ford F-150 with a step bumper we have the Draw Tite hitch part #41004 which is a confirmed fit.

view full answer...

Answer 4

When measuring the frame width on a vehicle, you will need to measure from the outside of one frame rail to the outside of the other frame rail. If you have the larger frame width of 37-1/4 inches you would want the Curt Hitch part #C15300, or if you…

view full answer...

Answer 5

From what I could find out, the Draw-Tite #41004 will sit below the frame rails and not inside them at all. So as long as your spare tire sits in between said frame rails, there will be absolutely no issue at all. I did include a picture of this…

view full answer...

Answer 6

The UWS Truck Bed Toolbox - Crossover Style - Single Lid Series - 6.9 cu ft - Gloss Black #UWS00327 or bright aluminum #UWS00076 are the TBS-54 options. There are also two low profile options in the #UWS00371 or #UWS00381. All of these installations…

view full answer...

Answer 7

There is always a way to make it work. I can't recommend doing that as I have not tested it and I do not offer a product like that with the exception of the Dexter Trailer Springs Over-Under Conversion Kit part #K71-384-00. This will give you a…

view full answer...

Answer 8

We don't carry in wall RV refrigerators like your Dometic DM2652 RBX so the closest compatible refrigerator we carry would be the Everchill RV Refrigerator w/ Freezer #324-000119. The dimensions I found for your current refrigerator show it being…

view full answer...

Answer 9

For your 1995 Ford F-250 with the 37" wide frame I recommend the Curt Trailer Hitch Receiver #14001 as long as you have the standard bumper, or step bumper. This hitch has a 1000lb tongue weight rating and 10000lb trailer weight rating to…

view full answer...

Trailer Hitch that Fits 1987 Ford F-150 with 6,000 lb Towing Capacity

Continue Researching