Set up: Curt Trailer Hitch Receiver on a 1996 Ford F-150 Video

From what I could find out, the Draw-Tite #41004 will sit below the frame rails and not inside them at all. So as long as your spare tire sits in between said frame rails, there will be absolutely no issue at all. I did include a picture of this…

The fact that you do not have holes on the frame of your 1989 Ford Bronco is not a problem. You will drill holes into the frame to install this Curt Hitch #14001 on your vehicle. The location of your spare tire will not be a problem either, check out…

Because the mounting flange of the Curt #C15511 Class V hitch has 3 tabs on each side, rather than a continuous mounting flange like many other hitches, it'll fit around the rivet shown in your photo. However, be aware that the Curt #C15511 is a…

The Curt 3-Piece Trailer Hitch Receiver #C15511 that you referenced is a great option for the deep drop bumper on your 1997 Ford F-350 Heavy Duty. The Draw-Tite #41504 is a little more cost-effective but it also requires the use of the adapter kit…

For your 1995 Ford F-150 with a step bumper we have the Draw Tite hitch part #41004 which is a confirmed fit.

When measuring the frame width on a vehicle, you will need to measure from the outside of one frame rail to the outside of the other frame rail. It sounds like you have the 37-1/4 inch frame on your 1983 Ford F-100. The Curt Class IV 2 Inch Hitch,…

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

I spoke with Lippert and they said the Kwikee 35 Series Electric RV 1-Step part #LC3691461 will be a direct replacement for the Coach Steps 725-0041. It will be a bolt-on install for the most part for the exception of changing out the door switch…

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

The Buyers Products Class 4 Service Body Short Hitch Receiver #3371801053 has a universal bolt hole mounting pattern. It will fit mounting locations from 28-7/8" to 42-7/8" wide. This Class IV receiver is rated for a maximum tongue weight…

The mounting holes the Curt Trailer Hitch Receiver #14053 measure 38-1/4" and 38-3/4" width-wise and then from the center of the of the forwardmost to the rearmost is 13-1/4". Attached is a dimensional photo for you to reference. This…

From the top of the mounting plates to the top of the B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25124 receiver is a 5-1/4" drop and then from the rearmost bolt hole to the end of the receiver is 10-7/8" (see attached).