How Should the 2-Piece Polypropylene Trailer Vent be Positioned when Installing
Published 06/12/2013 >
Products Featured in This Question
Question:
Which direction do you install the exterior portion of the half moon vent flat side up/down/forward/backward? Where is the best place to put a vent on a cargo trailer top front or back bottom?
asked by: Janice L
0
Expert Reply:
On the 2-Piece Polypropylene Trailer Vent, # WHMAV2-WAVT2, I would mount it near the top front of the trailer with the vent openings pointed down or towards the rear of the trailer. Ultimately, it does not really matter. Use some self-tapping screws like # 31071 and some sealant like # 0160297 when installing the vent.
expert reply by:
Michael H
0
Product Page this Question was Asked From
2-Piece Exterior Wall Vent for Enclosed Trailers - Polypropylene - 3" Diameter Hole - White
- RV Vents and Fans
- Vent
- Wall Vent
- No Fan
- Plastic
- White
- Redline
more information >
Continue Researching
- Q&A: Recommended AC System to Replace Two Dometic Duo-Therm AC Units Controlled by the Same Thermostat
- Q&A: Side Wall Vent Recommendation for an Enclosed Trailer for Maximum Air Flow
- Q&A: What is Max Air Pressure for Lionshead Steel Modular Trailer Wheel LH44ZR
- Q&A: Troubleshooting Brake Controller Install on 2017 Ford E-350 that Activates Brake Lights Connected
- Q&A: Door Hinge for 2001 Exiss Horse Trailer
- Q&A: Replacement Tail Light Lens for Tracker Trailstar Trailer
- Q&A: Best Replacement for a Wesbar Tail Light 271594
- Article: Best RV Roof Vents
- Article: How to Replace or Install an RV Roof Vent
- Article: Redarc Tow-Pro Elite Full Review
- Article: How to Measure for Trailer Hitch Drop
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: Trailer Lighting Requirements

