Need A Cover For My 2013 Flagstaff Pop Up.

Question

Question:

I have a 2013 flagstaff hw27ks camper i need a all condition cover that will also go over the ac unit mounted on top What do you recommend

asked by: Justin M

0

Expert Reply:

I recommend the Adco SFS AquaShed RV Cover for Pop-Up Camper - Up to 18' Long - Gray # 290-12295. It will give you enough room to cover your AC unit and keep everything protected.

expert reply by: David B

0

Flagstaff Pop Up
(click to enlarge)

Answer 1

It sounds like you are already on the right track. You can indeed use an adapter like the Pollak #PK12716 for this purpose. This will plug in to the 7 way plug on your Tesla Model Y, and give you a 4 flat connector on the other end, which you can…

view full answer...

Answer 2

From what I could find it looks like your 2015 Aliner Evolution camper is 22' long. If this is the box itself then you need the Adco SFS AquaShed RV Cover for Hi-Lo Travel Trailers #290-12252 but if that 22' length includes the trailer tongue…

view full answer...

Answer 3

Your pop up is right at 12 feet in length so for a cover the Classic Accessories Deluze PolyPro III part #CA80039 would be what you would want. It also fits well with your AC unit as it is designed to accommodate them. I attached their fit dimension…

view full answer...

Answer 4

For your 15 foot pop-up camper I highly recommend the Adco SFS AquaShed RV Cover for Pop-Up Camper #290-12294 because its top layer is designed to repel water while also protecting your camper from the sun's UV rays, keeping the exterior looking…

view full answer...

Answer 5

When storing an A-frame style pop up it's generally recommend to store it in the up position if the trailer is going to see heavy snow fall since the snow would fall off of it mostly. But otherwise it's best to store it down to limit exposure…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…

view full answer...

Answer 12

To determine the correct size RV storage cover for your Coleman Lantern LT Travel Trailer you'll need to measure the body length. In the attached picture below you'll see exactly how to measure. Once you have this measurement you can choose…

view full answer...

Need A Cover For My 2013 Flagstaff Pop Up.

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching