What are the Dimensions of Optronics Flush Mount LED Backup Light BUL35CB
Published 05/17/2013
Products Featured in This Question
Question:
No dimensions are shown for this light BUL35CB
asked by: Mark A
0
Expert Reply:
The LED backup light # BUL35CB is 5-5/16 inches long x 3-7/16 inches wide x 2-5/16 inches deep. You will also need a wiring pigtail, # A45CB to install this light. For a grommet, use # A33GB. I have included a picture showing the light dimensions for you.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
Optronics LED Backup Light for Truck or Trailer - Submersible - 16 Diodes - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Rectangle
- Recessed Mount
- Non-Submersible Lights
- LED Light
- 5-5/16L x 3-7/16W Inch
- White
- Optronics
more information >
Continue Researching
- Q&A: How to Wire Reverse Lights on a Trailer with a 4-Way Trailer Connector
- Q&A: Replacement Hub Drum for Hayes 8k Trailer Axle
- Q&A: What Light Will Replace My Light with DOT 16P2ST2 T35 16 Stamped on it for My Truck?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement for Discontinued Bargman 30-91-010 and 30-91-011 Tail Lights
- Q&A: Replacement Bearings and Seal for an Al-Ko 12K Axle
- Q&A: Replacement Camera System For Furrion Vision FRC12TA-BL
- Q&A: Can Single Wire Clearance Light Be installed To Replace 2-Wire Light On Travel Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide