What Size Hole Is Needed For The Peterson Grommet PE26WR?
Updated 09/09/2021 | Published 09/04/2021 >
Question:
What is the dimension of the opening I have to make for the grommet?
asked by: Blaine A
0
Expert Reply:
I had the base of the Grommet for Peterson 850 Series Trailer Lights # PE26WR measured and it will be 5-1/2" x 3-5/8". With that said, I would go a hair under these measurements to make sure it is a good, snug fit.
expert reply by:
Lazer S
0
Product Page this Question was Asked From
Grommet for Peterson 850 Series Trailer Lights - Flush Mount - Black
- Accessories and Parts
- Trailer Lights
- Light Trim
- Black
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Peterson PET95FJ Amber LED Clearance and Side Marker Light Replacement
- Q&A: Peterson PET45FJ LED Clearance Light and 2 Prong Pigtail Plug
- Q&A: Are Shorter Length Hub Assemblies Available
- Q&A: Brake Controller Plug Location on 2021 Jeep Grand Cherokee
- Q&A: Marker Light Dimensions Without Grommet PET45FJ
- Q&A: Wiring Needed For Adding a 4-Way Flat Trailer Connector On a Toyota Land Cruiser With 24V Power
- Q&A: IS There a 4-Way Trailer Wiring Kit for a 1990 Toyota Hilux Diesel Import from Japan
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)


