Should You Predrill Holes When Installing A Solera Slide-Out Awning
Published 09/01/2021
Products Featured in This Question
Question:
Is it best to predrill holes for awning rail in fiberglass rv
asked by: Jim H
0
Expert Reply:
Since you should be using self-tapping screws you won't want to predrill the holes for your Solera RV Slide-Out Awning # LCV000163300 rail. You'll want the threads of the screws to have enough to grip onto. If you need additional screws and butyl tape to install your awning you can use # CAM25013.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Solera RV Slide-Out Awning - 157" Wide - White
- RV Awnings
- Slide-Out Awnings
- Extends 4 Feet
- 13 Feet Wide
- 152 Inch Wide
- 153 Inch Wide
- 154 Inch Wide
- 155 Inch Wide
- 156 Inch Wide
- 157 Inch Wide
- White
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Correct Solera RV Slide Topper For 153 Inch Flange-To-Flange Measurement
- Q&A: How Much Does a Slide Topper Typically Hang Over a Slide Out
- Q&A: Is There Replacement Screen for RV Screen Door?
- Q&A: Sizing the Solera RV Slide-Out Awning
- Q&A: Best Replacement Water Heater for a Atwood GC6AA-10E
- Q&A: How to Determine Correct Slide Out Awning for Trailer
- Q&A: Recommended Slide Topper Awnings for 155 Inch Wide Slide
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Gooseneck to 5th Wheel Adapters
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps