Can Multiple Monitors And Cameras Be Used With Furrion Vision S Wireless Backup Camera?

Published 08/27/2021

Products Featured in This Question

Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 5" Screen

(737)

$457.97

Pollak Light-Duty Toggle Switch - On-Off - 12 Volt - 10 Amp - 6" Wire Leads

(10)

$9.67

Question:

I have some questions about Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 5inch Screen. We are looking at possibly installing cameras in bay doors where visibility and blind backing of trailers are part of the operation. Do you need to use the same monitor for all the cameras or could you use multiple monitors on all the cameras. Example I have 4 cameras mounted in a bay and I run 3 jockey trucks will any monitor for these 4 cameras be able to connect.

asked by: Shawn H

Expert Reply:

The Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 5" Screen # FOS05TASF does have the ability to pair to multiple cameras or monitors, but only one at a time. It is sort of like a phone connecting to a Bluetooth device; several phones can connect to the Bluetooth device one at a time, and several Bluetooth devices can connect to your phone as long as there is only one at a time.

Also, the cameras require a 12v source and switch to power on which could be done with a battery and Pollak Light-Duty Toggle Switch # PK34513. You would have to switch on the camera or leave it on all the time and then pair up to the individual monitors as they pull into the bay.

expert reply by: Andrew N