Will the TorkLift Cannon Hitch Extension Fit a Chevrolet Silverado?

Question

Question:

I have a 2011 Chevy 3500 dually with a 3inch hitch. will this extension work with the Chevy? If not do you have one similar that will?

asked by: Eric H

0

Expert Reply:

I have a solution for you for but the TorkLift # TLE1636 is designed to only fit the Ford Super Duty factory hitch receiver. The bracket and support chains are designed specifically to the Ford receiver. To find a comparable length extension that will fit your 2011 Chevrolet Sliverado 3500 dually you're going to need to reduce your 3 inch receiver down to 2 inches. You will need item # BWRHXA2183 this is a B&W Hitch Receiver Reducer Sleeve. I recommend the Reese Hitch Box Extension and Reducer item # RP45292. This is a 24 inch to 34 inch long hitch box extension and has a 4,500 lbs max towing capacity at 34 inches.

expert reply by: Jerred H

0

Answer 1

Hey Jarred, there is no issue swapping your current axles out with the 3.5k axle-less system, the Timbren Axle-Less Trailer Suspension - Standard Duty #ASR3500S06; This system does also have the built in 4" lift you're looking for as well.…

view full answer...

Answer 2

Hey Bob, The TorkLift Cannon Hitch Extension #TLE1648 would be a good option if your F-350 has the factory 3" Ford receiver hitch and you're needing 48" of extension. You can measure to figure out the correct length needed, with or…

view full answer...

Answer 3

Hey Kyle, so I checked with Torklift and we actually have the numbers wrong on the 21 inch version. The #TL46CR is actually rated for 550 lb tongue weight and 5,500 lb total trailer weight.

view full answer...

Answer 4

Hello Mike, Sounds like you are getting things set up the right way and not going over your payload, I respect that. It looks like the weights are the same whether you have a 6 3/4' or 8' bed. If you happen to have an aftermarket hitch,…

view full answer...

Answer 5

Hello Joeseppi, Let's get you into the right camper tie-down. Just as long as your 2021 Ford F-350 does not have factory flip-out steps that are mounted under the bed you will want the TorkLift Tie Downs - Custom Frame Mount - Front and Rear…

view full answer...

Answer 6

The TorkLift Hitch Extensions are going to be measured for the extension from hitch pin hole to hitch pin hole. So for the Cannon series which fits a Ford 3" receiver we have the following sizes. 21" #TL46CR 24" #TL66CR 36"…

view full answer...

Answer 7

The only other extension that will meet your 36" requirement is the Titan Hitch Box Extension for 2-1/2" Trailer Hitches, 41" - 48" Long #RP45018. This extension would have a maximum gross trailer weight of 7,500 lbs/750 lbs of…

view full answer...

Will the TorkLift Cannon Hitch Extension Fit a Chevrolet Silverado?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching