Spacers to Use for Timbren Kit on 2009 Ford Ranger to Take Up 1-1/2 inch of Space
Published 08/10/2021
Products Featured in This Question
Question:
I had TFRR050A installed on my 2009 Ford ranger 2wd stock and there is over 2” before it touches the axel. What spacers would I need to close the gap to 1/2”
asked by: Gabriel
0
Expert Reply:
To get a total of 1-1/2 inch of spacer for your Timbren kit part # TFRR050A you'd need to use the 1 inch spacer part # A25723-90AH00 as well as a 1/2 inch spacer part # TA25722-90P00.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement 7-Leaf Double Eye Spring 25-1/8" Long
- Q&A: Timbrens or SumoSprings. Which One is Better for a 2020 Nissan Titan 4WD?
- Q&A: Comparing The Timbren # TNRTTNB And # TNRTTN For A 2024 Nissan Titan SV
- Q&A: Dimensions and Instructions for the Timbren Rear Suspension Enhancement for a 2008 Ford Ranger
- Q&A: Recommended Rear Suspension Enhancement And Weight Distribution Hitch For 2010 Ford Ranger
- Q&A: Timbren Suspension Kit Recommendation for 2002 Chevy S-10 ZR2
- Q&A: Solution for Broken Torque Wrench When Installing Andersen Ranch Hitch AM3100
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)