Parts Needed for Mounting SuperSprings Leaf Spring Stabilizers on 2008 Ford F-250

Question

Question:

I HAVE A 2008 FORD F250 AND NEED THE MOUNTING KIT FOR IT. CAN I PURCHASE JUST THE MOUNTING KIT? I HAVE THE SSA10

asked by: Ann M

0

Expert Reply:

You could use the SuperSprings Mounting Kit for OEM Leaf Springs Above the Axle # MTKT if you wanted the complete kit according to my contact over at SuperSprings International.

expert reply by: Erik B

0

Answer 1

The SuperSprings #SSA22 would be a smart choice to raise your 2012 Ford F-250 when pulling your fifth wheel. They are designed to prevent the sagging you are experiencing and should put you pretty close to level. If you take a look at the attached…

view full answer...

Answer 2

You certainly can use a SuperSprings Custom Suspension Stabilizer and Sway Control Kit on your 1999 Ford F-250 4WD with an air bag system installed. Out selection includes part #SSA16 with a 1,650 lb capacity, part #SSA22 with a 2,200 lb capacity,…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

There are two levels of adjustment on the SuperSprings Custom Suspension Stabilizer and Sway Control Kit part #SSA46 for your 2017 Ford F-350. The adjustment is located on the shackle that attaches the roller to the bottom of your leaf spring. There…

view full answer...

Answer 7

That's a good question, and you will keep the factory overload spring on your 2020 Ford F-350 Super Duty, as they are designed to fit directly over that spring. The correct SuperSprings kit for your '20 F-350, which will also work with your…

view full answer...

Answer 8

I can help you with suspension enhancement that will work great on your 2015 Ford F-350 but since your truck has a service/utility body that would normally indicate you have a cab and chassis model truck that has a narrower 34 inch wide frame and for…

view full answer...

Answer 9

The SuperSprings Suspension Stabilizer and Sway Control Kit #SSA13 is designed for your 2014 Ford F-250 without overload springs. A lockdown kit is required if the factory springs sit above the axle and the included poly spring pads are necessary.…

view full answer...

Answer 10

Hey Steven, The SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA46 is compatible with both models that do and do not have factory top overload springs those wouldn't prevent you from being able to install this kit. The air…

view full answer...

Answer 11

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Parts Needed for Mounting SuperSprings Leaf Spring Stabilizers on 2008 Ford F-250

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching