Will Yakima Smart-Slot Mounting Kit Fit Thule Wingbar Evo Channels

Question

Question:

Will this Yakima Smart-slot kit work with the Thule Wingbar Evo’s t-tracks?

asked by: Gary

0

Expert Reply:

Yes the SmarT-Slot Mounting Kit for Yakima HighSpeed and HighRoad Roof Bike Racks # Y02122 that you referenced does fit into the top channels of the Thule WingBar Evo crossbars.

expert reply by: Jameson C

0

Answer 1

I reached out to my contact at Lippert and based on the NV 248685 your 7000lb Lippert axle uses inner bearing #25580, outer bearing #14125A, and grease seal #GS-2250DL. Now this grease seal has a 2.250" I.D. which is the same as the seal you…

view full answer...

Answer 2

I checked with Yakima and they do offer the replacement rear plate for the Yakima ForkChop bike rack. That said, it is only available with the Rear Wheel Holder Assembly for Yakima ForkChop Bike Rack part #Y65FR which comes with everything to replace…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 12

Hey Jarrod, the 420 model isn't available just yet. We haven't received a estimated release date for that Dometic model. If you are interested in a comparable option or needing something sooner, the Dometic 410 #DMC44JF is what most of our…

view full answer...

Will Yakima Smart-Slot Mounting Kit Fit Thule Wingbar Evo Channels

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching