Bulldog 12k Jack Recommendation where the Pull Pin is on the Same Side as the Crank Handle
Updated 04/10/2013 | Published 04/09/2013
Products Featured in This Question
Question:
Can the leg be moved so you can pull the pin from the side, instead of the front of the jack ?
asked by: Elmo
0
Expert Reply:
What you would need is a Bulldog Square Jack # BD182804. This jack has the handle on the same side as the pull pin for the jack extension and should be exactly what you need.
I attached a review video for this product for you to check out also.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Why Would Surge Brake Actuator Not Want to Release Brake Pressure When Driving Forward
- Q&A: How to Remove Pin in Handle Shaft to Replace Gears on an Older Bulldog Model 12 Square Jack
- Q&A: Replacement Parts for Bulldog Square Jack
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Replacement Dexter Hub for 8-91A Hub
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions For Dexter Torflex #11 Axle Side-Mount Frame Installation Hardware # DX57FR
- Q&A: Lift Kit and Brackets for Top Mount Torflex 3500 lb Axles on Horse Trailer
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Measure a Trailer Axle
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Gooseneck to 5th Wheel Adapters