Can 30 Amp Portable Power Watchdog Surge Protector Be Used On 50 Amp Trailer

Question

Question:

Can you use a 30amp adapter on a 50 amp surge protector? I have a 50 amp trailer but often only use a 30 amp power cord. But some rv parks only have 50 amp service. the reason for using the 30 amp cord is so I dont have to lug around the heavy ass 50 anp cord

asked by: Larry H

0

Expert Reply:

I don't recommend using a 30 amp surge protector on a 50 amp trailer. This would require adapters and will limit power going to the trailer. Instead, for a 50 amp trailer, you'll need to use the Portable Power Watchdog Surge Protector with Bluetooth part # HU47FR.

expert reply by: Conner L

0

Answer 1

You will always use a surge protector matched to the TT's rating of 30 amps. I recommend the Power Watchdog the 30 amp Surge Protector with Bluetooth #HU97FR. You can use the free smartphone app to monitor your system and get notified if low or…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 8

Hey Tom, thanks for reaching out. Yes you are on the right track. The Ducted Air Distribution Box #LC64DX (2024040312) will indeed work with the Furrion Variable Speed Chill Cube RV Air Conditioner w/ Heat Pump #FR24TQ (2025008216). They are made…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

The CIPA Custom Towing Mirror - Driver Side #10801 that you referenced (which is also available in a set with part #CM10800) is confirmed to fit the following vehicles: 2002 - 2006 Chevrolet Avalanche 2000 - 2006 Cadillac Escalade 2002 - 2006…

view full answer...

Can 30 Amp Portable Power Watchdog Surge Protector Be Used On 50 Amp Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching