Are Spring Seats for Dexter E72GR 3500 Lb Axle Available Separately
Published 05/22/2021
Products Featured in This Question
Question:
the hub face measurement is correct but the perch placement is not can i get them seperated and weld them on myself ?
asked by: Robyn M
0
Expert Reply:
We do sell the spring seats or perches separately as part # TRSS238 which are sold individually. You can remove the existing spring seats or simply leave them in place if they don't interfere with anything, then weld the new ones where they're needed.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Trailer Axle with Idler Hubs - 4" Drop - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- Idler Hubs
- 3500 lbs
- 5 on 4-1/2 Inch
- 74 Inch Spring Center
- 89 Inch Hub Face
- Drop - 4 Inch
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Air Lift LoadLifter 5000 Air Helper Springs AL38FF Fit 2022 Ford Bronco With Sasquatch Package?
- Q&A: Replacement Hub/Drum and Bearings for 2006 Carmate Trailer With Dexter 8-247 Assembly
- Q&A: Do You Have a 2-inch Square Axle Rated for At Least 3,000lbs and Has Idler Hubs?
- Q&A: Can The etrailer Trailer Axle with Idler Hubs # e65GR Be Mounted Below the Leaf Springs?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Recommended Slider Base and Ram Puck System Adapter for a Curt A20 5th Wheel Hitch Head
- Article: How to Measure a Trailer Axle
- Q&A: Replacement Spindle For Jet Ski Trailer With 2,700 lb Capacity
- Q&A: Are Powder Coat Trailer Wheels Good for a Saltwater Boat Trailer ST205/75R14
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Lighting Requirements
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control