Jack Height Adjustability For The Lippert Ground Control 3.0
Updated 05/21/2021 | Published 05/20/2021 >
Question:
Can I raise the mounting height of the jacks for better ground clearance?
asked by: Bob
Expert Reply:
The rear jacks in the Lippert Ground Control 3.0 # LC358590 have multiple bolt patterns to allow you to fit different heights. It is important to ensure that you will still have enough travel to lift your camper properly for leveling. These jacks only have 12-1/2" of travel.
The front jacks have 21" of travel. If your trailer will allow for the jacks to be raised in the compartment you will want to ensure that the jacks either have new weld stops put on. Or you can mount new stops on the frame where you would like the jack to sit.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Does etrailer Carry Andersen Ultimate Safety Chain Attachment
- Q&A: Replacement Front Jack for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Ultra Fab Electric Landing Gear Replacement for 2006 Keystone Raptor 3319
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: Can I Grease or Lube the Inside of My Lippert 3.0 landing Gear?
- Q&A: Replacement Front Jack for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Troubleshooting External Sensor Error On Lippert Ground Control 3.0 LC358590
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: What is a Fifth-Wheel Camper
- Article: Where to Position the Trailer Axle?
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams


