Wiring & Fusing Power Power Station LIne to MaxxAir Fan
Updated 05/13/2021 | Published 05/12/2021
Products Featured in This Question
Question:
I am trying to wire the maxx air to a cigarette plug to go into my yeti 500x power station. The plug has a 10 amp fuse in it and I dont want to take it apart to change the fuse if I even could because they are impossible to get back together. Can I install a 5 amp in line fuse between the plug and the fan and still be protected?
asked by: Chris H
Expert Reply:
The MaxxAir # MA00-07500K claims to use 5 amps, so fusing it for 5 amps seems like zero tolerance for any power issue. I would fuse it a bit higher, like 7.5 amps.
You could use the Curt # C58470-1 in-line fuse holder. You will just need to pick up the actual fuse at an automotive store.
Product Page this Question was Asked From
MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Powered Lift
- 12V Fan
- Reversible Fan
- Plastic
- Tinted
- MAXXAIR
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Best RV Roof Vents
- Q&A: Looking for Replacement Bathroom Vent for 2009 Keystone Sprinter Travel Trailer
- Q&A: Best Replacement For Norcold N611 RV Refrigerator
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Replace or Install an RV Roof Vent
- Q&A: What is the Difference in the MORryde Hand Rail?
- Article: Trailer Wiring Diagrams
- Q&A: Will MaxxAir II Vent Cover MA76JR Be Compatible With MaxxFan 4751K?
- Q&A: Replacement Lid/Dome for MaxxFan 4751KS
- Q&A: How to Power a Furrion Camera System w/ a 2024 Chevrolet Silverado 3500
- Q&A: Troubleshooting Furrion Vision S+ Monitor Not Displaying Camera
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Lighting Requirements
- Article: Best Vehicles to Flat Tow Behind an RV