Which 2-inch Hanger is Used for the Rear hanger Slipper Springs?
Published 08/19/2009
Question:
What hanger is used as the rear hanger on slipper springs
asked by: Skip
0
Expert Reply:
On 3,500 to 9,000 lb axles with 2-inch wide slipper springs, the Hanger for 2" Slipper Spring 5-1/16" Tall, part # 721585, can be used as the front, center and rear hangers.
expert reply by:
DeAnne T
0
Product Page this Question was Asked From
Rear Hanger for 2" Wide Slipper Springs - 5-1/16" Tall - 9/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Camper
- Car Hauler
- Utility Trailer
- Slipper Springs - 2 Inch
- 9/16 Inch Diameter
- 5-1/16 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- etrailer
more information >
Continue Researching
- Q&A: Do I Need Longer Shackle Straps to Install the MORryde ALLTREK 4000?
- Q&A: Replacement Brake Assemblies for AL-KO T-44 Axles
- Q&A: How Much of a Slipper Spring Should be Sticking Out Past the Rear Hanger
- Q&A: How to Determine Correct Equalizer Upgrade For Triple Axle Toy Hauler
- Q&A: How To Choose Correct MORryde Shackle Upgrade Kit
- Q&A: 1/2 X 13 Threads Per Inch Vintage Trailer Wheel Bolts
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Maintenance Schedule
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings