How Do Trailer Clearance Lights Normally Get Replaced
Updated 04/20/2021 | Published 04/16/2021
Products Featured in This Question
Question:
How do I replace a burnt out clearance light on my 2018 Thor freedom elite? Is it an outside or inside fix?
asked by: Doug Z
Expert Reply:
Your picture is a little blurry but from what I can see it looks like a clearance light that fits into a grommet that fits a hole in your RV. How they normally install is you put the grommet into the hole and then push the light in after from the front. If you can access behind the light you should be able to push it out or you can pry it out from the front. If the light is broken and most likely it doesn't have a bulb that could be replaced I wouldn't worry too much about damaging the housing.
It looks like it could maybe be a # MCL10AKB which is 3/4 inch in diameter.
(click to enlarge)
Continue Researching
- Search Results: breakaway charger
- Search Results: switch
- Shop: Replacement Breakaway Switch for Bright Way Trailer Breakaway Kits
- Shop: LED Trailer Mini Clearance and Side Marker Light with Grommet - Submersible - 1 Diode - Amber Lens
- Shop: Blue Ox 12 Volt Power Outlet Kit - Direct Wire - 15 Amp - Qty 1
- Video: Replacement Battery Charger for Bright Way Trailer Breakaway Kit: The Breakdown
- Q&A: Replacement Break-Away Battery For A 1985 Horse Trailer With A ES5-12 SLA Battery
- Shop: Optronics LED Mini Clearance or Side Marker Trailer Light - Submersible - 2 Diodes - Red Lens
- Shop: TecNiq PCP2 Marker Light - Self Ground - Red
- Shop: Buyers Products Toggle Switch with 2 Blade Terminals - Recessed Panel Mount - 12 Volt
- Shop: Miro-Flex Thinline LED Trailer Clearance or Side Marker Light - Sumbersible - 4 Diodes - Red Lens
- Video: All You Need to Know About the Buyers Products Toggle Switch with 2 Blade Terminals
- Video: Replacement Breakaway Switch for Bright Way Trailer Breakaway Kits: The Breakdown
- Video: Rivet Gun with 4 Nose Pieces Spec Review
- Video: A Closer Look at the Rivet Gun with 4 Mounted Nosepieces
- Video: Let’s Check Out the Peterson Spitfire Low Profile Round Trailer Reflector
- Video: A Closer Look at the Uni-Lite LED Clearance and Side Marker Light w Grommet
- Q&A: Difference Between Dexter and etrailer Hub/Drum Assembly for 3,500 lb Axles
- Q&A: Inserting Wire Connections to Interior When Installing # MCL13A2B Clearance Light on Toyota Camper
- Q&A: Bolt Hole Spacing for the etrailer Electric Trailer Brakes
- Q&A: Utility Trailer Upgrades: Toolbox, LED Taillights, and Spare Tire Holder
- Q&A: Replacement Brakes and Hub and Drum Assemblies that Use L68149 and L44649 Bearings
- Q&A: What Would Trailer Axle Capacity be if Wheel Bolt Pattern was 5 on 4-3/4 inch
- Article: Trailer Wiring Diagrams
- Search Results: reflector
- Search Results: reflective tape
- Search Results: wire management
- Search Results: cotter pins
- Search Results: e track