Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This small but powerful 1" round amber LED light puts out a clean, bright beam while drawing only 0.03 – 0.06 amps at 12V DC. With just one high-quality diode rated for up to 100,000 hours of operation, it’s built to stay bright for years without the hassle of bulb changes. The LED runs efficiently across a 9V – 14V range and stays visible even in low-light or nighttime towing situations.
This light is made to handle water exposure without failure. Its lens and housing are sealed together as one piece, making it completely waterproof and submersible. The circuit board is encapsulated in TecSeal urethane potting, which protects better than epoxy by locking out moisture and dust. With an IP68 rating, it’s built to survive repeated dunking and wet road conditions without corroding or shorting out.
You get both side marker and clearance coverage in one light thanks to its PC rating. It shines a 180-degree arc of amber light—90 degrees to each side of center—so it’s visible from the front and the side at once. That wide beam pattern helps make your trailer easier to spot from multiple angles, increasing safety when towing or parking in dim areas.
Mounting this light takes minimal effort. It fits into a standard 3/4" diameter cutout using the included rubber grommet for a snug recessed mount that stays flush and protected. The two-wire harness keeps wiring straightforward: black for ground and white for power. The attached 18" pigtail gives you plenty of length for connection without extra splicing or extensions.
The impact-resistant polycarbonate housing is engineered for outdoor use, with automotive-grade UV resistance that prevents yellowing or cracking over time. Its military-grade circuit board and urethane potting keep vibration and moisture from causing failures, ensuring consistent performance through weather, water, or rough terrain—all while meeting or exceeding FMVSS 108 standards.

Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at this TecNiq recessed mount, mini amber LED, side marker trailer light. Now, this is a nice, small, round LED light that'll serve as a side marker and clearance light for your trailer. It's in a nice sealed waterproof housing and lens unit, and it is IP 68 rated. Does offer military-grade construction of the circuit board, and it uses urethane potting, which offers better protection than the common epoxy potty.
The LED is a premium LED. It is energy efficient, long-lasting and vibration resistant. It is rated for up to 100,000 hours of operation. The lens is a durable UV resistant lens, and it is an amber lens over one amber LED. Now, this is compatible with 12 volt DC systems.
It is a recessed mount installation. Comes with the included grommet for installation, and it will require a 3/4 inch diameter cut-out for this to install in. Now, you can add a stainless steel trim ring for a nice finished look if you'd prefer. We do sell them separately on our website and they're listed on this product page as a related product. This is a two wire harness which will hardwire to your application.
It includes a white ground wire and a black power wire. Total wire length on this is about 18 inches. It is a PC-rated light, so it will produce 180 degree beam when properly installed. And this does meet or exceed the Federal Motor Vehicle Safety 108 Standards. Now, I'm gonna hook this up to some power to show you how bright the light is.
First, I wanna give you dimensions on it. The diameter of it is right at one inch. The depth of it, front to back is right at 7/8 of an inch. Input voltage, nine volts to 14 volts. And the power draw is only .03 to .06 amps. So, we're gonna go ahead and hook up our ground wire and then we'll hook up our power wire. And you can see once it's hooked up and the power's on, it gives you a nice amber light. We'll go ahead and turn off our, and it's a single LED over, with an amber lens over it. So, you can see it gives off a very bright amber light. And I'll go ahead and turn back on our overhead lights then turn off our power. But that should do it for the review on this TecNiq recessed mount, mini amber LED, side marker trailer light..
Ratings & Reviews

Mike L.
4/30/2026
We're glad to hear that, good job!

Nick S.
12/1/2025
That is great to hear! I am glad the process was easy and I hope the install was as well. It looks great on your vehicle!

Mike L.
2/18/2026
The pigtail wires are 16-gauge which is typical. Hope that helps!!
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.







Brooke M.
5/9/2025
Awesome! What type of boat do you have?