Modifying / Trimming Corrner of SnapPad EQ Round Jack Pads
Updated 04/15/2021 | Published 04/14/2021 >
Products Featured in This Question
Question:
My 2020 fleetwood discovery lxe 40m had the power gear 10 inch jacks. The front jack dish is close to a cross bar corner as shown in the picture. Can I trim the snap pad to allow installation?
asked by: Rick C
Expert Reply:
Modifying the SnapPadEQ Round Jack Pads , # SP64FR4, by trimming is not something that has been tested. Because these function by pressure that type of modification may have negative effect. These are not only sold in sets but individually as well for replacement needs. I suggest buying one and testing its fit, # SP64FR.
Product Page this Question was Asked From
SnapPad EQ Round Jack Pads for Equalizer Leveling Systems w/ 10" Round Jack Feet - Qty 4
- RV Jack Pads
- 10 Inch Jack Foot
- 4 Jack Pads
- Round Foot
- Equalizer Leveling System
- Permanent
- Black
- SnapPad
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Jack Foot Pads For A 2016 Newmar Canyon Star 3710
- Article: Trailer Wiring Diagrams
- Q&A: Testing a Vehicle Side 7-Way Trailer Connector for Proper Function
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How to Clear Retract Time Out Return Levelers Error on LCI Level Up System
- Q&A: Will The SnapPad EQ Jack Pads Bend And Return To Original Shape Over Uneven Surface?
- Q&A: Which SnapPad Fits 2019 Berkshire 34QS that Has 10 inch Octagon Feet
- Q&A: Can etrailer Electric Jack e74GV be Used with 7-Way of 2025 Ford F-250
- Q&A: Recommended A-Frame Electric Jack w/a 7-Way Connector for a Trailer w/out a Battery
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)


