Recommended Jack Foot Pads For A 2016 Newmar Canyon Star 3710

Question

Question:

We have a 2016 Newmar canyon star 3710. It has the equalizer leveling system. The jack feet are octagon shape. They measure 10inch from end to end on outside. Inside round hole is 8 3/4 to 9. Which model number pad do I need. Thank you

asked by: James H

1

Helpful Expert Reply:

For 10" octagon shaped jack feet you would need the SnapPad EQ Octagon Jack Pads # SN76FR that you were already looking at, but before purchasing you'll need to measure just how tall the edges stick up from the ground since your jack feet curl up. The pads that we offer only have a gap large enough to handle 1/4". If the edges raise higher than 1/4" then you wouldn't be able to use SnapPads and would need to use the Stromberg Carlson RV Jack Pads for Equalizer Systems - 10" Round or Octagonal Jack Feet # SC56MR instead.

expert reply by: Kevin C

1

Jack Foot 1
(click to enlarge)

Jack Foot 2
(click to enlarge)

Answer 1

Yes, the SnapPad EQ, #SN76FR will fit 10" octagon or concave round jack feet.

view full answer...

Answer 2

Since you have 10 inch octagon feet on your jacks the correct SnapPads is the part #SN76FR. I can't verify the fit of anything off Amazon.

view full answer...

Answer 3

Hey Henry, yes we do have the Snappads of the part #SN76FR that you referenced individually with the part #SP84FR. Did you lose one by chance?

view full answer...

Answer 4

I would love to tell you exactly what you need but unfortunately that is not possible. The reason for this is that not all 2022 Jayco Precept 31UL's come with the same leveling system from the factory. If you call and ask Snap Pad, they'll…

view full answer...

Answer 5

Hey Dan! What are you experiencing when you tow your trailers? If you're getting rear sag with a little bit of body roll I would get the Coil SumoSprings #CSS-1168R for the additional suspension support. If you're primarily getting a lot of…

view full answer...

Answer 6

For the 10" diameter octagon shaped jack feet on your Equalizer Leveling System I recommend the SnapPad EQ Octagon Jack Pads for Equalizer Leveling System w 10" Octagon Jack Feet- Qty 4 #SN76FR. These heavy-duty rubber pads snap onto your…

view full answer...

Answer 7

Given the issue you described and the fact that you have done a good job of troubleshooting and checking other potential sources for the issue, it sounds like the motor is going bad. Since you mentioned the landing gear working fine for a little bit…

view full answer...

Answer 8

Yes, the SnapPad EQ Octagon Jack Pads for Equalizer Leveling System w 10" Octagon Jack Feet #SN76FR reshape back to the original shape after they are used on uneven surfaces. The SnapPad EQ Ocotagon Jack Pads #SN76FR will work on any type of…

view full answer...

Answer 9

The SnapPad EQ, #SN76FR will fit 10" octagon or concave round jack feet.

view full answer...

Recommended Jack Foot Pads For A 2016 Newmar Canyon Star 3710

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching