How Thick is the Ball Platform on Curt #45503
Updated 04/12/2021 | Published 04/07/2021
Question:
How thick is the hitch material at the ball mount?
asked by: Dave F
0
Expert Reply:
The platform where a ball would install on the # C45503 is 1/2 inch. There can be slight variations due to the powder coat finish, but only slightly. The shank on the # C45503 is a completely solid 1 1/4 inch milled bar, but again, there can be very slight variations due to the powder coat.
expert reply by:
Lazer S
0
Product Page this Question was Asked From
Curt Class II Drawbar - 3/8" Rise, 1" Drop - 7-13/16" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 1 Inch
- Rise - 1 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- CURT
more information >
Continue Researching
- Q&A: What Hitch will Not get in the Way of My 2025 Subaru Forester Hands Free Lift Gate?
- Q&A: What is Included with Curt Trailer Hitch 12038 for a 2008 Subaru Forester
- Q&A: How Do I Know How High The Ball Should Sit Above the Ground
- Q&A: Replacement Surge Brake Actuator For Trailer W/ Older Swing Away Actuator For Disc Brakes
- Q&A: Is There A Replacement Lens Available For A Wesbar 105825?
- Q&A: Cross Reference Chart for Kodiak Trailer Disk Brake Pads to Automotive Applications
- Q&A: How To Choose Correct Replacement Leaf Springs for a Shorelandr Boat Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: Practice Safe Trailer Towing with These 4 Tips
- Article: RV Pre-Departure Checklist
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)