Parts Needed to Install Brake Controller on 2008 Toyota Highlander
Updated 04/05/2021 | Published 04/01/2021
Products Featured in This Question
Question:
I have purchased and installed DrawTite hitch #75726. I intend to tow a small Rv travel Trailer less than 5000 pounds. The Trailer brakes will require a seven pin connector. What proportional controller would you recommend and what wiring harnesses will I require. The drivers cockpit has an airbag under the steering wheel which may limit the mounting options for a controller Also, do you know if the seven pin connector will mount directly to the DrawTite mounting bracket that is part of the hitch? Thanks in advance,
asked by: Robert A
Helpful Expert Reply:
To convert the 4-way of your 2008 Toyota Highlander to a 7-way and install a brake controller you'd need the part # ETBC7 which comes with everything you'd need and has a bracket that will bolt up to the welded on wiring bracket of the # 75726 you have.
Since you have limited room on your dash due to the air bag setup like you mentioned a brake controller like the Redarc Tow Pro Elite # RED44FR would be a great option as it allows you to only have to mount a small knob on the dash or center console.
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Wiring and Brake Controller Set up For a 2003 Ford Van E350
- Q&A: Comparing the Universal Installation Kit # ETBC7 and the 7-Way RV Upgrade Kit # ETBC7L
- Q&A: Recommended Brake Controller and Wiring Harness for a 2006 Dodge Ram w/a Factory 4-Way
- Q&A: What Wiring do I Need to get My 2022 Toyota Highlander Ready for Redarc Tow-Pro Brake Controller?