Which Grease Cap For Hub With 1.940" Bore
Updated 03/16/2021 | Published 03/11/2021
Products Featured in This Question
Question:
Could you point me in the right direction? Im looking for replacement caps and possibly bearing assemblies. I have an 18’ Quality Steel 7k lb trailer. The axels are marked Lippert 285876. I measured inside the hub at 1.94” but not sure if that is 100 accurate since it was measured on a completed assembly. I have bot opened a hub yet since i was hoping to do with parts on hand. Thank you
asked by: Matt L
Expert Reply:
For the 1.940" bore on your hubs you will need the Fulton Grease Cap - 1.943" Outer Diameter - 1-3/8" Tall - Drive In # F001524, but to determine the correct bearing assemblies you will need to do a little disassembly as I was unable to confirm which bearings you axle uses.
You will need to remove one of your current hubs and look for the bearing numbers stamped in the face of each of the bearings as shown in the included picture of the # L44649.
If your bearings are worn to the point that you cannot read the bearing numbers you will need to use digital calipers like # PTW80157 to precisely measure your spindles according to the included diagram.
If you can provide the bearing numbers or spindle measurements I would be happy to confirm the correct bearings for your trailer.
I included a video of the # F001524 for you to take a look at.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Fulton Grease Cap - 1.943" Outer Diameter - 1-3/8" Tall - Drive In
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.94 Inch O.D.
- 1.94 Inch
- 2000 lbs Axle
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Grease Cap Recommendation for Hub with 1-15/16 inch Hub Bore
- Q&A: Do You have Grease Caps for a 1.935 Bore Diameter Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Axle Upgrade For Ironton 5 X 8 Utility Trailer
- Q&A: Replacement Bearing Kit for TDE 46845 Hub
- Article: How to Measure a Trailer Axle
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Q&A: Grease Cap Recommendation for Trailer Hub with 1.938 inch Bore
- Q&A: How to Measure a Trailer Hub or Dust Cap to Find the Right Replacement Dust Cap
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)