Thread Pitch of Studs on Trailer Hub # AKIHUB-655-6-K
Published 11/25/2020
Products Featured in This Question
Question:
Looking for the wheel stud thread pitch and size please.
asked by: Todd M
0
Expert Reply:
The trailer hub part # AKIHUB-655-6-K that you referenced uses standard 1/2 inch trailer wheel studs like the part # 165981. This is a coarse thread (UNC) with a thread pitch of 1/2 inch x 13 threads.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 6,000-lb Axles - 6 on 5-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Idler Hub
- Pre-Greased
- Standard
- 25580 / 15123
- Standard Grade
- For 6000 lbs Axles
- 1/2 Inch Stud
- 6 on 5-1/2 Inch
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: Recommended 12" Nev-R-Adjust Electric Trailer Brake Assemblies
- Q&A: Does etrailer Axle with Pre Greased Hubs Require Putting More Grease In the Hub
- Q&A: Replacement Braking Assembles for an AL-KO 7,200 lb Axle
- Q&A: Replacement Driver And Passenger Side Brake Calipers For A 1997 Ranger Boat Trailer
- Q&A: How to Find Replacement Electric Drum Brakes for a Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: How To Find Correct Replacement Grease Seal for a Trailer Axle
- Q&A: Parts Needed to Swap UFP A-70 Surge Coupler to Work W/ Electric-Over-Hydraulic Brakes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern