How To Attach Loose Wires to Class T Fuse Block for Go Power Inverter
Question:
I have 3/8L” ends on my cables which are 2/0 cables how do you attach to your class T fuse holders? Looks like they only take bare wire. Thx
asked by: Paul L
Helpful Expert Reply:
In order to attach your battery cables to the Go Power Inverter Fuse with Block - Class T - 300 Amp # 34244227REVA, you'll just need some ring terminals like the Spectro Ring Terminal - 2/0 Gauge - 3/8" Ring ID - Copper - Zinc Plated - Qty 1 # SWC57048Z. This ring terminal is designed for 2/0 gauge wiring like you've got and you'll just use the included nuts with the Go Power Inverter Fuse with Block to hold the ring terminals on the posts.
Products Referenced in This Question
Spectro Ring Terminal - 2/0 Gauge - 3/8" Ring ID - Copper - Zinc Plated - Qty 1
- Wiring
- Wire Connectors
- Ring Terminals
- 3/8 Inch Diameter
- 2/0 Gauge
- Spectro
more information >
Product Page this Question was Asked From
Go Power Inverter Fuse with Block - Class T - 300 Amp
- Accessories and Parts
- RV Power Inverter
- Fuses
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: 2-1/2 Inch Shank for a Blue OX BXW1000 Weight Distribution System
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Dimensions of Lippert Underchassis Double Bin Storage Unit for RVs # LC175180
- Q&A: Highest Rated Gas Shock for RV Door
- Q&A: How to Determine Correct Gas Shock for Trailer Door
- Q&A: Roof Opening Dimensions For Installing RV Air Conditioner
- Q&A: Will Two 12V Batteries be Enough to Power the 3000W Go Power Inverter # 34275013 for a Short Time
- Q&A: Progressive Dynamics Power Converter PD4045KA Replacement Converter Section