Diameter Of The Loop On Each End Of The Redline 8 inch Lanyard Part # 2608
Updated 09/23/2020 | Published 09/21/2020
Question:
Could you tell me what the diameter of the loops is? On a BigTex trailer the lanyard is held in place on one end by a 5/8ths inch bolt so a small loop will not work. Thanks
asked by: John M
Expert Reply:
The 8" Long Lanyard # 2608 has two loops, one on each side. The loops measure 1/2 inch long 1/4 inch wide. Go to your local hardware store and grab a bolt/self tapping screw that the threaded portion falls within the dimensions of the loop. The head of the bolt/screw should be bigger than the loop just to prevent it from slipping off. You want to have the majority if not all the loop underneath the head of the hardware you use.
If you want to learn more about the Lanyard, I've included a video with more info!
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Hub For Outer Bearing LM11949 & Inner Bearing LM67048
- Q&A: How Does Buyers Products Pin with Lanyard # 3373006875 Fasten to Trailer?
- Q&A: No Trailer Connection on Tekonsha P3 Brake Controller 90195 on a 2000 Toyota Tundra
- Q&A: Dimensions Of The Over The Seal Strap Hinge # PLR2116-SS
- Q&A: Tie Down Anchor Point for Top of Rhino Rack Vortex Crossbars
- Q&A: Rhino-Rack Drop-In Channel Eye Bolts With Zwifloc Channel Nuts For Pioneer Platform
- Q&A: Compatibility of A-Frame Tool Box with Spare Tire Carrier on 20 Foot Big Tex Tilt Trailer
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Lighting Requirements
- Article: How to Change a Trailer Tire