Pairing Side Furrion Side Cameras to Correct Monitor Position

Updated 08/20/2020 | Published 08/18/2020

Question:

I installed furrion side cameras on my 2021 Grand Design solitude when trying to pair the cameras to the monitor the left camera automatically says succeed but alls it did reprogrammed the rear camera to the left light when I try to pair the right camera it says failed I tried to reprogram the rear camera and it will not pair to the monitor it automatically defaults to the left camera but yet its the rear camera on the screen

asked by: Bob L

Expert Reply:

In order to un-pair the camera on your Furrion RV Observation System # FOS05TASF and assign it to the correct designation you will first just need to press the button at the bottom of the camera itself and hold it down for 15 seconds. This will un-pair the unit.

Once this is done you will just follow the original pairing steps again as outlined in the instructions manual (and also attached below) to set it as the rear camera.

expert reply by: Jameson C