Attaching Wishboned Trailer Wiring to Standard Wire
Updated 08/10/2020 | Published 08/07/2020
Question:
white to white,green to green.yellow to yellow,Due i put the two brown wires with the brown wire.
asked by: Doug M
0
Expert Reply:
Yes, it sounds like you are attaching wishbone trailer wiring for the running light circuit to a standard single wire running light circuit so you would run the two brown wires to the single brown and you'd be set.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot
- Wiring
- Wire
- Bonded Wire
- 4 Wire
- 16 Gauge
- Deka
more information >
Continue Researching
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Can A No-Drill Bracket Be Installed On A Hitch With A Square Crosstube?
- Q&A: Will The Optronics Flexible LED Light Strip UCL90CB Stick Under A Trailer/Camper?
- Q&A: Will TowSmart T-Connector Wiring Harness Fit 2016 Chevy Colorado
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Q&A: Wiring Instructions for Derale Temperature Gauge
- Article: Trailer Lighting Requirements
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Testing The Dexter Electric Over Hydraulic Brake Actuator
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle