Recommended Parts for 2004 Ford E250 5.4 V8 Towing Trailer
Updated 08/04/2020 | Published 08/02/2020 >
Products Featured in This Question
Question:
Im wondering what I need and what options I ought to consider adding to my van for towing a 23.5 foot hitch to bumper travel trailer that has a dry weight of 5,000 pounds and a gross weight rating of 7,000 pounds. The trailer has electric brakes and an Anderson weight distributing hitch. My van came with the factory hitch and wiring installed hitch says 1,000 pound weight limit for the tongue and max gross trailer weight of 10,000 pounds. I know I need a brake controller and it looks like the Redarc Tow-Pro Elite would be a good choice along with the Ford-specific wiring adapter I can see where it plugs down near the drivers feet in my van. Its worth mentioning that the van is a camper conversion with a bit under a thousand pounds of add-ons. With passengers and gear I suspect well end up within a thousand pounds of the vans 13,000 pound combined weight rating. I expect to spend some time going over mountain passes and the like, and will also do some dirt roads that will sometimes be washboarded and/or somewhat potholed. I know I will have to dial my speed back a lot more than Im used to w/o a trailer. I will also be getting towing mirrors - either the clamp-ons or the telescoping ones that replace my OEM mirrors. Is there anything else I should consider adding/modifying on this van?
asked by: Jim O
Expert Reply:
You have the basics covered with the brake controller and tow mirrors but I would also recommend a transmission cooler like part # D13503 with the adapter part # D13024 and # D13014. This is going to do a great job prolonging the life of your transmission as heat is the number one killer of them and towing creates quite a bit of heat.
Then to install the Redarc Tow Pro Elite part # RED44FR you'd just need the install harness part # RED87FR and for tow mirrors the custom install set # CTM2500 and you'd be set.
Product Page this Question was Asked From
Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets - Class III - Efficient
- Transmission Coolers
- Plate-Fin Cooler
- Mid-Size Truck
- SUV
- Van
- Standard Mount
- 11W x 8-3/4T x 7/8D Inch
- With 11/32 Inch Hose Barb Inlets
- Derale
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Hitch, Wiring, Brake Controller, and Transmission Cooler for a 2006 Honda Pilot
- Q&A: Best Transmission Cooler For 2007 Honda Pilot 4WD
- Q&A: Transmission Cooler Recommendation for 2018 Nissan Frontier
- Q&A: Recommended Transmission Cooler for a 2018 Nissan Altima
- Q&A: Does The Redarc RED82CR Come With The Switch Panel For A 2008 Toyota Tacoma?
- Q&A: When To Use a Weight Distribution System When Towing with a 2011 Honda Odyssey
- Q&A: Weight Distribution Replacement Solution Reese Mini 350 with Lost Components
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Article: Which Hitches are Made in the USA
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com


