Ball Mount Recommendation for Draw-Tite Trailer Hitch Installed on 2018 Honda CR-V

Updated 07/23/2020 | Published 07/21/2020

Products Featured in This Question

2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs

(1362)

$15.49

Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-3/16" Span

(2959)

$4.58

Curt Fusion Ball Mount for 2" Hitches - 2" Ball - 2-1/4" Rise - 7,500 lbs

(475)

$32.94

Curt Ball Mount for 2" Hitches - 5" Rise, 6-1/8" Drop - 9-3/8" Long - 10,000 lbs

(3914)

$52.50

Question:

Hi! Im planning on buying a Draw-Tite hitch 76128 for my 2018 Honda CR-V. Do you have any suggestions for which ball mount and ball I should get with it? Id like to have the 2 ball height at about 18.5inch inches, if possible. Thanks!

asked by: Jack F

Expert Reply:

When we installed the Draw-Tite Trailer Hitch # 76128 on a 2018 Honda CR-V we found that from the ground to the top inside of the hitch receiver measured 13-1/4". This means that if you need the top of the ball at about 18-1/2" then you need a ball mount with about a 2-1/4" rise.

If the bottom of your trailer coupler to the ground measured 18-1/2", when level, then that would mean you actually need a rise of 5-1/4".

For the 2-1/4" rise I recommend the Curt Fusion Ball Mount # C45155 which is a complete kit, and for the 5-1/4" rise I recommend the Curt Ball Mount # C45336 with the Pin & Clip # C21500 and the 2" Hitch Ball # 63845.

Also, don't forget your wiring so that you have a complete towing kit! For that you need the Tekonsha T-One # 118741.

Attached are some installation videos for you to check out.