Mounting License Plate Lamp Vertically
Updated 09/20/2012 | Published 09/18/2012
Products Featured in This Question
Question:
I have a carry-on cargo 6x12 enclosed and looked at your parts - can I mount the light vertically?
asked by: Jeff D
0
Expert Reply:
As long as the DOT regulations in your state allow a vertically mounted license plate light, you can certainly mount the lamp in a vertical rather than a horizontal orientation.
We also offer the same lamp in an LED version, part # LPL41CB. LED lamps will draw only a fraction of the power of a comparable incandescent bulb, but will last much much longer.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Optronics Trailer License Plate Light - Incandescent - Gray Housing - Clear Lens
- Trailer Lights
- License Plate Lights
- License Plate
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 1-3/4W Inch
- White
- Optronics
more information >
Continue Researching
- Q&A: Will The Lippert Quick Drop RV Stabilizer Jack LC68DK Fit A Jayco 27 RSDL?
- Q&A: Availability Of 5 on 4-1/2" Hubs For A 3/4" Spindle
- Q&A: Can Fuse Tap be Used to Acquire Brake Signal for Brake Controller Install of 2017 Toyota Highlander
- Q&A: Looking For Replacement Hubs, Wheels And Tires For Mastercraft Boat Trailer
- Q&A: Troubleshooting Compressor for Firestone Air Springs that Won't Shut Off
- Q&A: Replacement Aluminum Trim For Cargo Trailer That is 1-1/2 Inches Tall
- Q&A: Replacement Trailer Clearance Light for a Haulmark Trailer
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Tell the Weight Rating of a Trailer Axle