Availability of Grease Seal to Fit ID 2.125" and OD 3.265"
Updated 06/12/2020 | Published 06/10/2020
Question:
Is there a double lip grease seal to fit a bore of 3.265 and a shaft size of 2.125? I’ve been searching and can’t find anything your help is appreciated
asked by: Richard S
0
Expert Reply:
The closest thing that we have to those measurements is the Grease Seal # 21325 which has an ID of 2.125" and an OD of 3.269". The 0.004" difference between the OD that you measured and the OD of this grease seal is not enough for it to not be compatible. In fact, the slightly larger size OD means that it will fit that much more snug and help to prevent grease escaping.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Grease Seal - Double Lip - 21325
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 2.13 Inch I.D.
- 3.27 Inch O.D.
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Bearing/Race/Seal Kit for Boat Trailer w/ NOK AD7131E Seal 25580 Inner and LM67048 Outer Bearing
- Q&A: What Timken Bearings, Races, Washer, and Cotter Pin do I Need for My 2,200 BTR Spindle/Axle?
- Q&A: Wiring Instructions for the Tradesman Vaquero Hydraulic A-Frame Trailer Jack
- Q&A: Replacement Grease Seal for 2024 Keystone 5th Wheel With Dexter D60 Axle
- Q&A: Should Equalizer and Shackles Be Replaced After Being Shoved Out of Position
- Q&A: Determining The Correct Replacement Equalizer And Shackle Straps For A 2017 Forest River 5th Wheel
- Q&A: Replacement For Grease Seal 32374 For Trailer
- Article: Trailer Wiring Diagrams
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Bleed Your Trailer Surge Brakes