Dimensions from Pin Hole to End of Handle for Bulldog Gear and Handle Kit
Updated 05/11/2020 | Published 05/07/2020
Question:
What is the distance from the pin hole to the end?
asked by: David L
0
Expert Reply:
From the pin hole to the end of handle that comes with the Replacement Sidewind Handle and Gear Kit # BD500256 measures right about 2-1/4". I have attached a photo for you to check out.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Replacement Sidewind Handle and Gear Kit for Bulldog Round Jacks - 2,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Sidewind Gear Kit for a Bulldog 190754 Jack
- Q&A: Replacement Handle Recommendation for Bulldog Sidewind Trailer Jack # BD180455
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Bearing Kit & Seal For Dexter 031-030-02, 031-032-02 Bearings
- Q&A: Replacing Trailer Buddy 32220 Reverse Solenoid on Ranger Boat Trailer
- Q&A: Pin Hole to End of Shaft Dimension for the Bulldog Replacement Jack Handle Part # BD500105
- Q&A: Does The Insta Holding Tank Patch Kit # SR48RR Adhere To Polyethylene
- Q&A: Determining Correct Grease Seal and Axle Capacity on Vintage Trailer
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Best Boat Trailer Jacks
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule