Troubleshooting Trailer Running Light Circuit Not Working on Left Side Fender
Updated 04/30/2020 | Published 04/29/2020
Question:
I have a car GoPro 6.5 x12 aluminum trailer, my left side fender light does not work. What could it be?
asked by: Ron
0
Expert Reply:
Most likely a bad ground for the light assembly on that fender. Since it's an aluminum trailer make sure the ground wire of the light is ran back to the main ground wire of the trailer and you should see it start to work again.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diode - Oval - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: Can I Fix Wallowed Out Wheel Stud Hole on Trailer?
- Q&A: Replace Hub Assemblies With Bearing Buddies For A 2,000 Lb. Trailer Axle
- Q&A: How to Install a B&W Patriot Hitch in a 2025 Chevy Silverado 2500
- Q&A: Replacement Screen Frame and Interior Trim for a VD0433 Roof Vent
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Replacement Converter for a Elixir ELX-45
- Article: Converting Your RV Water Heater to Tankless
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes