What Size Holes Does the Optronics Snap-In Mini License Plate Light Fit
Updated 02/20/2024 | Published 04/10/2020
Question:
Will this fit in a hole close to 1 inch?
asked by: Billy W
0
Expert Reply:
The Optronics Snap-In Mini License Plate Light part # LP11CB is designed to fit inside a 1-1/4" diameter hole, no more and no less. Therefore, if you only have a 1" diameter hole then you would need to enlarge this another 1/4" in order for the light to work.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Optronics Snap-In Mini License Plate Light - Incandescent - Round - Chrome Plated - Clear Lens
- Trailer Lights
- License Plate Lights
- License Plate
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 1-1/2 Inch Diameter
- White
- Optronics
more information >
Continue Researching
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: What Will Cause Excessive Wear on the Outside of the Tire on a Single Axle Cargo Trailer
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: Does Kenda Karrier KR53 ST205/75R15 Radial Trailer Tire with 15" Black Mod Wheel Come Balanced
- Q&A: Troubleshooting Overheating Hubs on a Trailer With New Bearings and Grease
- Q&A: Dual Jack Landing Gear for Gooseneck Trailer Transporting Large Water Tank
- Q&A: Powered Landing Gear Recommendation for a Loaded PJ Work Trailer
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: What Do I Need To Tow A Trailer?
- Article: Rust Prevention
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Determine Tire/Wheel Diameter
Jerry
2/20/2024
what size hole for a commercial trailer plug