Replacement Gray Water Tank Reducer Adapter from 3 Inch to 1-1/2 Inch
Updated 04/13/2020 | Published 04/10/2020
Products Featured in This Question
Question:
Road trash sheared the waste bayonet fixed at the side of the camper, and pulled the shower gray tank gate valve away from the 1 1/2 inch line from the shower waste tank. I need the reducer assembly there is a 3 in inside union with gasket joins the tank to the reducer adapter 3 - 1 1/2, and the gate valve assembly. The main body of the gate valve appears ok, but both of the nipple adapters are broken. I may be interested in a complete gate valve assembly. I cannot find the part numbers. I purchased a generic 3 to 1 1/2 eccentric reducer which looked like it would fit inside the tank outlet, but was the wrong outer diameter, and was too big for the tank outlet. Hence the need for the correct assembly or parts.
asked by: Mark W
Expert Reply:
It sounds like you are looking for the Valterra Eccentric Tank Reducer part # T1041-1 which installs in an RV gray water tank with with 3" diameter opening and then reduces this down to 1-1/2". The adapter will install inside the neck on the tank and then secured with gasket maker part # LT37467 and a band clamp part # H03-0009. In order to replace the waste valves you can then use the Double RV Waste Valves part # T80A depending on your setup. Please note, you'll also need the Valterra ABS Solvent Cement part # A05-0303 to complete the install.
I actually just performed this repair myself not too long ago and have attached a video on this for you as well to assist.
Product Page this Question was Asked From
Valterra Eccentric Tank Reducer - RV Gray Water - 3" Spigot to 1-1/2" Hub
- RV Sewer Hose Fittings
- Sewer Adapters
- Sewer Couplers and Nipples
- Reducer Couplers
- Hub
- Spigot
- Sewer Pipe to Sewer Outlet
- 1-1/2 Inch Diameter
- 3 Inch Diameter
- Valterra
more information >
Continue Researching
- Shop: Valterra Eccentric Tank Reducer - RV Gray Water - 3" Spigot to 1-1/2" Hub
- Shop: LaSalle Bristol RV Sewer Slip Hub with Flange - 1-1/2"
- Shop: RV Exterior Lighting
- Video: The Low-Down on the LaSalle Bristol RV Sewer Slip Hub with Flange
- Shop: LaSalle Bristol Cable-Actuated RV Waste Valve for Gray Water Tank - Spigot to Hub - 72" Cable
- Shop: LaSalle Bristol Eccentric Tank Reducer - RV Gray Water - 3" Spigot to 1-1/2" Hub
- Q&A: 3 inch to 1-1/2 inch Reducer for RV Sewer Piping
- Shop: Valterra ABS Solvent Cement - 1/4 Pint
- Shop: Valterra Eccentric Tank Reducer - RV Gray Water - 3" Spigot to 2" Hub
- Video: Valterra Drip Cap and Waste Valve Cap for RV Sewer Hose: The Breakdown
- Search Results: cargo trailer ladder rack
- Shop: LaSalle Bristol Long Sweep Elbow Fitting for RV Sewer System - ABS Plastic - 90 Degree - 1-1/2"
- Video: Breaking Down the LaSalle Bristol RV Sewer Spigot with Flange
- Search Results: lasalle bristol rv sewer hose fittings
- Video: Complete Breakdown of the Valterra Eccentric Tank Reducer
- Q&A: Are There Installation Differences Between LaSalle Bristol, Valterra, And Camco Wastewater Valves
- Search Results: accessories and parts
- Search Results: rv awnings
- Video: The Low-Down on the LaSalle Bristol Eccentric Tank Reducer
- Video: The Low-Down on the LaSalle Bristol Waste Valve for RV Gray Water Tank
- Q&A: Do Solera Replacement Batteries and Awning Switch Wire to Each Other
- Q&A: Removing and Installing Valterra Eccentric Tank Reducer # T1041-1
- Q&A: Fittings Needed To Expand 1-1/2" Sewer Pipe To 3" Pipe
- Search Results: 1 1/2 abs pipe
- Video: Set up: Double RV Waste Valves on a 2018 Forest River Grey Wolf Travel Trailer
- Q&A: How to Wire Replacement Switch for Solera 18V Power RV Awning
- Q&A: Troubleshooting A Lippert 18 Volt Power RV Awning
- Search Results: trailer tires and wheels
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
on RV Sewer Hose Fittings
