Diameter of Threaded Portion of BV0199-03 Replacement Roof Vent Switch For Ventline Roof Vents
Published 04/07/2020
Question:
Hi, I need a replacement switch for my 12V Hengs Jensen Roof Vent. Looks like this one might work. The outside diameter of the threads on mine is about .375 Can you tell me what the outside diameter is of the BV0199-03? If not .375, is there another one that you have? Thanks
asked by: Carl B
0
Expert Reply:
The threaded portion of the # BV0199-03 Replacement Push Button Switch is .368 of an inch, as shown in the provided photo. It sounds as if this switch would work fine for your needs.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
Replacement Push-Button Switch for Ventline Trailer Roof Vents
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Switches
- Ventline
more information >
Continue Researching
- Q&A: What is the Correct Replacement Fan Motor for Ventline PH-8 Range Hood?
- Q&A: Replacement Option For Atwood OD-5001 Water Heater
- Q&A: Correct Replacement Wall Switch for MaxxAir Vent Fan
- Q&A: How Many Pumps of Grease Should be Put in an Axle
- Q&A: Do You Still Carry the Dometic Penguin II High Capacity Heat Pump 9600003813?
- Q&A: Compatibility of Reese Goose Box With Recessed Gooseneck Ball on Flat Bed Truck
- Q&A: Recommended 3.19" Pilot Hole Diameter Center Cap for Viewing an Oil Hub
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Replace or Install an RV Roof Vent
- Article: Trailer Wiring Diagrams