Galvanized Fenders for my Boat Trailer

Question

Question:

I have 13 inch tires on my galvanized boat trailer and would like to replace the fenders. The current fenders are 7.5WX 26.5L and 9.25 Tall bottom of fender to the top. Would like to use existing brackets. See Pics. Do you think your product CE17800G would fit. Please let me know if pics dont come through. Thank You and I look forward to your input.

asked by: Kevin G

1

Helpful Expert Reply:

Yes the E Smith Single Axle Trailer Fender - Pre-Galvanized Steel - 13" Wheels part # CE17800G will be the perfect solution. You will add the attachment holes to match your current brackets. I recommend treating that area with some clear spray paint to help prevent corrosion. Happy Boating!

expert reply by: Randy B

1

Answer 1

CE Smith Single Axle Trailer Fender #CE17800G does not have pre-drilled holes, so you will have to drill them. You can reuse your original mounting hardware and brackets or you can use the bolt on brackets, #CE26098G-2. These mounting brackets have…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

view full answer...

Galvanized Fenders for my Boat Trailer

Product Page this Question was Asked From

Continue Researching