What Is the Bolt Hole Spacing On the Valterra Flush Mounted Telescoping Water Inlet
Published 04/02/2020
Question:
what are the bolt hole measurements
asked by: Robert S
0
Expert Reply:
The distance between the mounting holes on the Valterra Flush Mounted Telescoping Water Inlet part # R920TW is 2-1/2" on center left to right and top to bottom. I have attached a video for you with these exact measurements.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Valterra Telescoping RV Gravity Fill Water Inlet - Plastic
- RV Water Inlets
- Gravity Fill Inlet
- Flush Mount
- Plastic
- White
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are The Provider ST205/75R15 Radial Trailer Tires TR20515D Mud And Snow Rated?
- Q&A: Need A Replacement G6A-8E Water Heater For RV.
- Q&A: Can I Run The Dometic RV Water Heater DMC74FR On Electric Only?
- Q&A: Can A Gas/Electric Atwood/Dometic RV Water Heater Be Switched To Use Only Electric
- Q&A: Comparing Outdoor Shower Box Brands For The Highest Quality Replacement
- Q&A: What is the Strongest ST205/75R15 Tire?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Shower Pan For Slide In Truck Bed Camper
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub