Where Is the Brake Controller Port On An Entegra Coach Vision Motorhome

Updated 08/22/2024 | Published 01/27/2020

Question:

Trying to find the wires or connector in a 2020 entegra vision motorhome. Ford chassis

asked by: Jay

Expert Reply:

The Entegra Coach Vision is built on a Ford F-53 Chassis which means there should be a pre-wired brake controller port under the dash. The exact location of this port can vary but most likely it will be on the left side of the steering column support which you can see shown in the attached photo. If you don't already have a brake controller in mind, the Tuson DirecLink Base Model Trailer Brake Controller part # 335DL-100 gets my approval as it is one of the most advanced controllers on the market with the ability to read all sorts of vehicle parameters such as transmission fluid temperature and it has what is known as a low-speed brake adjustment which aids in braking during stop-n-go traffic so you don't wear out the trailer brakes and get as smooth of a ride as possible.

The Custom Wiring Adapter for Trailer Brake Controllers part # 3035-S can then be used to install the Tuson DirecLink without splicing into the coach.

expert reply by: Conner L

click to enlarge

Joe

8/22/2024

This is not correct. I have nothing that looks like this plug in this location. 2020 f53 chassis on a 2021 entegra vision 29s coach. I have looked everywhere for this plug AND the new style plug and have found nothing. I looked under the kick plate, under every area and have not found it.. Has to be tucked in somewhere way up behind the dash or somewhere else.